You can remove the front bumper piece (and still have the base screwed on) to make the car look more accurate, of course, but then you need to make a new piece to fill the gap. I just left it on.
Trying to find a way to stop the red light shining out from the headlights, I placed a strip of white card (shiny side out) behind the non-functioning headlight windows. This didn't work, as the light actually travels through the clear plastic and around the edges. I think it would have to be painted to completely block out the light.
BUT the white card behind the windows looks cracking, a bit like the KITT render on the homepage.
I also put a strip of red card (again, shiny side facing out) under the row of LEDs. Push it all the way back so that the edge is touching the PCB. The red card does two things. It makes a more visible red line during daytime, and in the dark it makes the scanner light slightly more visible from above angles. I experimented with metallic red card but it doesn't work as well. Plain red card is the way to go.
I hope you like these suggestions
